Products
w-446
- Type:W Series
- CAS No:
- Qty in 20' FCL:
- Min. Order:
- Packaging:
-
W-446PumpParameters
Stroke,min-1
300
250
200
175
50
100
50
Inputpower(horsepower)
446
355
285
250
213
142
71
Cylinder diameter
Pressure
Gallon,run-1
Gallon,run-1
6
1050
2.203
661
550
440
386
330
220
110
5-1/2
1248
1.851
555
463X
370
324
278
185
63
5
1508
1.530
459
310
306
268
230
153
76
4-1/2
1863
1.239
372
245
248
217
186
124
62
4
2357
0.979
294
188
196
171
147
98
49
3-1/2
3000
0.750
225
188
150
131
113
75
38
( Mechanical efficiency 90%, coefficient of fullness α=100%, and volumetric efficiency 100% )
-
W-440/446(500HP)pumps can be widely used in all types of operations in an oilfield. The liner sizes range from 6 to 3 1/2, which are suitable to adopt piston structure for well maintenance and shallow drilling. The pumps with liner sizes of 3 1/42 adopts piston structure and such pumps can be used in conditions with high pressure. The pump is compact in structure, and has a small size therefore it is light. The gear pairs are in a integral herringbone structure and the transmission torque is large.
Frame The machine frames are welded with steel plates and processed to eliminate stress after welding, therefore. There are reinforced plates at the seats of crankshaft and main bearing so that they have good stiffness and strength
Crankshaft The crankshaft is in a balanced structure with welded forged parts. It is light and can operate smoothly without vibration. The both sides of the crankshaft are equipped with double aligning spherical roller bearings so as to ensure the stability in operation and to improve its bearing capacity.
Pinion Shaft It is made of forge alloy steel, herringbone gears (integral) is machined on the shaft and it adopts medium hard tooth surface. There is shaft extension at both ends, where bell pulleys or chain wheels may be installed
Crosshead The crosshead is made by one-piece cast with nodular cast iron, so the crosshead has good resistance to abrasion. The structure of top and bottom guidance is adopted for crossheads in order to regulate the concentricity by adding gasket at the bottom guidance. The extension rods are connected to the crossheads by flange bolts with pin holes, so as to ensure the concentricity of the crosshead and the extension rods. The packing adopts double layer sealing structure which realizes good seal performance
Fluid Cylinder The cylinder is made of forge alloy steel and adopts a straight-way structure The hydraulic cylinder has a small size and higher volume efficiency. The cylinder surface is processed by chemical plating in order to increase the resistance to corrosion. The three hydraulic cylinders of a pump are interchangeable
Liner W440/446(500HP)pumps have the same liner O.D. The liners are mounted tightly on the end face of hydraulic cylinder by using squareness capping and bolts. Sealing between the liner and the hydraulic cylinder is realized by rectangular rubber gaskets
lubrication System The pump adopts forced lubrication In the oil tank, there is a gear oil pump, which transmits pressure oil to crossheads guidance as well as the bearings, so as to ealize forced lubrication and cooling.
Spraying System It adopts a power driven spraying system.